These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B158D87 | Video Signal Stoppage Missing Message | A component internal image signal communication malfunction is detected
(2 trip detection logic) |
Navigation receiver assembly |
| B15A096 | LAN Master Component Internal Failure | When any of the following conditions is met:
(2 trip detection logic) ·
Bus malfunction ·
Internal power source malfunction ·
Internal hardware malfunction ·
DSP malfunction ·
EEPROM malfunction ·
Storage malfunction |
Navigation receiver assembly |
| B15AD96 | Navigation Processor Component Internal Failure | When any of the following conditions is met:
(2 trip detection logic) ·
Gyro sensor malfunction ·
GNSS receiver malfunction ·
G sensor malfunction |
Navigation receiver assembly |
| B15B396 | Radio Tuner Component Internal Failure | A radio tuner internal communication malfunction is detected
(2 trip detection logic) |
Navigation receiver assembly |
| B15B796 | Bluetooth Module Component Internal Failure | A "Bluetooth" module internal malfunction is detected
(2 trip detection logic) |
Navigation receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Clear the DTCs.
Turn the ignition switch off.
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B158D87, B15A096, B15AD96, B15B396 or B15B796 is output | B |
A
B