K313 CVT CONTINUOUSLY VARIABLE TRANSAXLE FLUID REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during CVT fluid replacement are shown below.
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of CVT fluid | Air bleed the oil pump with motor assembly | Stop and Start System | ( 201906,999999,_51,_080774,_0393362,RM100000001HXHH,)
|
| ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly | (201906,999999,_52,_080728,_0392261,RM100000001HP98,)
|
PROCEDURE
51410
1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
51444A
2.REMOVE REAR ENGINE UNDER COVER LH
3.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE FLUID
4.ADD SPECIFIED AMOUNT OF FLUID
5.BLEED AIR FROM OIL PUMP WITH MOTOR ASSEMBLY
6.ADJUST FLUID TEMPERATURE (when Using the GTS)
7.ADJUST FLUID TEMPERATURE (when Not Using the GTS)
8.ADJUST FLUID LEVEL
9.PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET
- NOTICE:
-
If approximately 50% or more of the CVT fluid has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.
10. REBUILD WORK
51444A
11.INSTALL REAR ENGINE UNDER COVER LH
51410
12.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY