The inverter with converter assembly monitors its internal operation and will store this DTC if it detects a malfunction of its EEPROM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Note |
|---|---|---|---|---|---|---|
| P062F46 | Generator Control Module(EEPROM Learning Value) Calibration / Parameter Memory Failure | ECU internal malfunction
(EEPROM error) (1 trip detection logic) |
Inverter with converter assembly | Comes on | Master Warning:
Comes on |
SAE Code:
P062F |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and wait for 15 seconds or more. [*1]
[*1]: Normal judgment procedure.
The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.
Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.
Be sure to check that the applicable DTC is output from the motor generator control system.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| P062F46 is output from the motor generator control system. | A |
| P062F46 is output from any system other than the motor generator control system. | B |
Turn the ignition switch off.
A
B