SEAT OCCUPANT DETECTION SENSOR(for 60/40 Split Seat Type 60 Side) REMOVAL
CAUTION / NOTICE / HINT
- CAUTION:
- ·
Wear protective gloves. Sharp areas on the parts may injure your hands.
·There is risk of injury.
- HINT:
- ·
Use the same procedure for RHD and LHD vehicles.
·The procedure listed below is for LHD vehicles.
PROCEDURE
1.REMOVE NO. 3 SEAT ASSEMBLY RH
73315B
2.REMOVE REAR NO. 3 SEAT INNER BELT COVER RH
72345V
3.REMOVE NO. 4 SEAT STAND FRAME CAP RH
72057E
4.REMOVE REAR NO. 1 SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH
71848V
5.REMOVE NO. 3 SEAT ADJUSTER COVER CAP RH (w/ Center Headrest)
73350
6.REMOVE REAR CENTER SEAT LAP TYPE BELT ASSEMBLY (w/ Center Headrest)
71834P
7.REMOVE RH SEAT REAR NO. 3 SEAT RECLINING COVER
72525Q
8.REMOVE NO. 3 SEAT RECLINING ADJUSTER RELEASE HANDLE RH
72215C
9.REMOVE NO. 3 SEAT TRACK HANDLE CONTROL LEVER RH
79076P
10.REMOVE NO. 3 SEAT LEG COVER SUB-ASSEMBLY RH
71H75S
11.REMOVE RH SEAT RECLINING ADJUSTER INSIDE COVER
12.REMOVE REAR SEAT CUSHION ASSEMBLY
72345W
13.REMOVE NO. 3 SEAT STAND FRAME CAP LH
72057H
14.REMOVE REAR NO. 2 SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
15.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
79335B
16.REMOVE NO. 3 SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR)
Remove the hog ring.
Remove the 8 hog rings and No. 3 seat cushion cover sub-assembly RH from the No. 3 seat cushion pad RH (occupant detection sensor).
- NOTICE:
-
Be careful not to damage the No. 3 seat cushion cover sub-assembly RH.