RM35X0E _58 Vehicle Interior _079316 HEATING / AIR CONDITIONING _0386651 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Blower Motor does not Operate  


DESCRIPTION

If no air is discharged even when the air conditioning control assembly is operated, the following causes are possible.

Malfunction Status Factor
No air is discharged.
·

Blower with fan motor sub-assembly malfunction (+B and GND circuit)

·

Control signal malfunction between air conditioning assembly and blower with fan motor sub-assembly

·

Blower with fan motor sub-assembly malfunction

·

Air conditioning control assembly malfunction

·

Warm-up control

·

Water temperature sensor malfunction



PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM (MANUAL MODE)
a.

Operate the manual mode to check that the blower with fan motor sub-assembly is operated normally.

OK:

Blower with fan motor sub-assembly is operated normally with manual mode.



Result:
Result Proceed to
OK (except 1GD-FTV (w/ Exhaust Gas Temperature Sensor for EGR)) A
OK (for 1GD-FTV (w/ Exhaust Gas Temperature Sensor for EGR)) B
NG C



A

2.READ VALUE USING GTS (COOLANT TEMPERATURE)

B

3.READ VALUE USING GTS (COOLANT TEMPERATURE)

C

2.READ VALUE USING GTS (COOLANT TEMPERATURE)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List.


e.

Read the Data List according to the display on the GTS.

Powertrain > Engine
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
HINT:
·

After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.

·

If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

·

Check if the engine overheats if the value indicated is higher than 135°C (275°F).



Powertrain > Engine > Data List
Tester Display
Coolant Temperature
50003 372 205
OK:

The temperature after warming up is as specified in the normal condition column.



Result:
Proceed to
OK
NG



OK

NG

3.READ VALUE USING GTS (COOLANT TEMPERATURE)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and Transmission / Data List.


e.

Read the Data List according to the display on the GTS.

Powertrain > Engine and Transmission > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
HINT:
·

After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.

·

If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

·

Check if the engine overheats if the value indicated is higher than 135°C (275°F).



Powertrain > Engine and Transmission > Data List
Tester Display
Coolant Temperature
50003 456 237
OK:

The temperature after warming up is as specified in the normal condition column.



Result:
Proceed to
OK
NG



OK

NG