The ABS motor relay and pump motor are built into the brake actuator assembly.
If the skid control ECU (brake actuator assembly) detects a malfunction in the drive circuit of the pump motor, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C052C49 | ABS Pump Motor Control Internal Electronic Failure | ·
The skid control ECU (brake actuator assembly) detects a malfunction in the pump motor circuit. ·
When the system has started, a short to +B is detected during the ABS motor drive circuit self test. |
Skid control ECU (brake actuator assembly) |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | The system has started. | - | ○ |
| Malfunction Status | The skid control ECU (brake actuator assembly) detects a malfunction in the pump motor circuit. | ○ | - |
| A short to +B is detected during the ABS motor drive circuit self test. | - | ○ | |
| Detection Time | - | - | |
| Number of Trips | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Replace the skid control ECU (brake actuator assembly).
| Proceed to |
|---|
| NEXT |
NEXT