RM38T0EC
_58
Vehicle Interior
_112290
POWER OUTLETS (INT)
_0606057
WIRELESS CHARGING SYSTEM
J
POWER OUTLETS (INT) WIRELESS CHARGING SYSTEM Wireless Charger Power Source Circuit
DESCRIPTION
This is the power source circuit for the mobile wireless charger cradle assembly.
WIRING DIAGRAM
0.531,0.615 1.594,0.885
1.063,0.271
10
false
from ACC Relay
2.74,0.813 3.448,1
0.708,0.188
10
false
ECU-ACC
4.583,0.625 4.927,0.813
0.344,0.188
10
false
ACC
4.583,1.615 5.104,1.802
0.521,0.188
10
false
PGND
4.323,2.125 4.844,2.313
0.521,0.188
10
false
I287
4.313,2.302 7.01,2.531
2.698,0.229
10
false
Mobile Wireless Charger Cradle Assembly
4.385,1.51 4.51,1.708
0.125,0.198
10
false
3
4.396,0.521 4.521,0.719
0.125,0.198
10
false
1
CAUTION / NOTICE / HINT
- NOTICE:
-
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
1.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY POWER SOURCE)
a.
Disconnect the I287 mobile wireless charger cradle assembly connector.
b.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition I287-3 (PGND) - Body ground Always Below 1 Ω
c.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection Switch Condition Specified Condition I287-1 (ACC) - Body ground Ignition switch ACC 11 to 14 V
- Result:
Proceed to OK NG
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR