The power steering ECU assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque.
While DTC C151162, C151187, C151262 or C151287 is detected, power assist is stopped or assist amount is limited due to fail-safe operation.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate |
|---|---|---|---|---|
| C151162 | Power Steering Torque Sensor "A" Signal Compare Failure | Diagnosis Condition: IG ON
Malfunction Status: The difference between 1A and 1B of the TRQ1 output signal is more than a certain value. |
·
Torque sensor (Electric power steering column sub-assembly) ·
Power steering ECU assembly |
EPS warning light: Comes on |
| C151187 | Power Steering Torque Sensor "A" Missing Message | Diagnosis Condition: IG ON
Malfunction Status: When the auxiliary battery voltage is 9.0 V or more, the TRQ1 signal is not detected, breaks communication protocol, has a CRC error, or has an invalid rolling counter. |
·
Torque sensor (Electric power steering column sub-assembly) ·
Power steering ECU assembly |
EPS warning light: Comes on |
| C151262 | Power Steering Torque Sensor "B" Signal Compare Failure | Diagnosis Condition: IG ON
Malfunction Status: The difference between 2A and 2B of the TRQ2 output signal is more than a certain value. |
·
Torque sensor (Electric power steering column sub-assembly) ·
Power steering ECU assembly |
EPS warning light: Comes on |
| C151287 | Power Steering Torque Sensor "B" Missing Message | Diagnosis Condition: IG ON
Malfunction Status: When the auxiliary battery voltage is 9.0 V or more, the TRQ2 signal is not detected, breaks communication protocol, has a CRC error, or has an invalid rolling counter. |
·
Torque sensor (Electric power steering column sub-assembly) ·
Power steering ECU assembly |
EPS warning light: Comes on |
When the electric power steering column sub-assembly has been replaced, perform Power Steering ECU Initial Setting (assist map writing).
When the power steering ECU assembly has been replaced, perform Power Steering ECU Initial Setting (assist map writing).
Replace the power steering ECU assembly.
Replace the electric power steering column sub-assembly.
| Proceed to |
|---|
| NEXT |
NEXT