DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Communication D-Door Motor | Connection status between power window regulator motor assembly (driver door) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
DTC is output if an error occurs in LIN communication. |
| Communication P-Door Motor | Connection status between power window regulator motor assembly (front passenger door) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
DTC is output if an error occurs in LIN communication. |
| Communication RR-Door Motor | Connection status between power window regulator motor assembly (rear door RH) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
DTC is output if an error occurs in LIN communication. |
| Communication RL-Door Motor | Connection status between power window regulator motor assembly (rear door LH) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
DTC is output if an error occurs in LIN communication. |
| Communication Intrusion Sensor 1 | Connection status between map light sub-assembly (intrusion sensor) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
Although the item is displayed on the GTS, it is not applicable to this vehicle. |
| Communication Intrusion Sensor 2 | Connection status between map light sub-assembly (intrusion sensor) and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
Although the item is displayed on the GTS, it is not applicable to this vehicle. |
| Communication Sunshade ECU | Connection status between main body ECU (multiplex network body ECU) and roof sunshade ECU (sliding roof drive gear assembly) | OK or STOP | OK: Connected
STOP: Not Connected |
Although the item is displayed on the GTS, it is not applicable to this vehicle. |
| Communication Slide Roof | Connection status between main body ECU (multiplex network body ECU) and sliding roof ECU (sliding roof drive gear assembly)* | OK or STOP | OK: Connected
STOP: Not Connected |
DTC is output if an error occurs in LIN communication. |
| Communication Master Switch | Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU) | OK or STOP | OK: Connected
STOP: Not Connected |
DTC is output if an error occurs in LIN communication. |
*: w/ Sliding Roof System, Panoramic Moon Roof System