If the remote engine start ECU does not respond to the certification ECU (smart key ECU assembly) or the remote engine start ID is not registered, this DTC is stored.
Registration status of the remote engine start ECU ID can be checked using the "Wireless C Code" item in the Data List.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B277A96 | Wireless Starter Component Internal Failure | One of the following conditions is met (1 trip detection logic*):
·
A remote start communication error occurs. ·
Response is not possible. ·
Registration has not been performed. |
·
CAN communication system ·
Remote engine start ECU ·
Certification ECU (smart key ECU assembly) |
DTC output confirmation operation:
A remote start operation is performed. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine does not start with remote start operation | Engine cannot be started by remote start operation only |
| DTC No. | Data List and Active Test |
|---|---|
| B277A96 | - |
When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Key. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The smart entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart entry and start system (for Start Function) after confirming that the communication systems are functioning properly.
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Check for CAN communication system DTCs.
for GTMC Made Gasoline Model:
for SFTM Made Gasoline Model:
CAN communication DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for GTMC Made Gasoline Model:
for SFTM Made Gasoline Model:
Register the remote engine starter ID.
Registration can be completed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the remote engine starter function.
Remote engine starter functions operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG