This DTC is stored when the blind spot monitor sensor RH (A) judges that there is a communication problem with the blind spot monitor sensor LH (B).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U023387 | Lost Communication with Side Obstacle Detection Control Module "B" Missing Message | The blind spot monitor sensor RH (A) cannot receive signals from the blind spot monitor sensor LH (B) | ·
Blind spot monitor sensor LH (B) ·
Blind spot monitor sensor RH (A) |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
Clear the DTCs.
Check for DTCs.
DTC U023387 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
DTC U023387 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG