This DTC is output when an open circuit or short occurs in the communication line between a front center ultrasonic sensor (FLC sensor) and the front corner ultrasonic sensor (FL sensor), or when a malfunction occurs in a front center ultrasonic sensor (FLC sensor) on the front.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE287 | Ultrasonic Sensor (Front Left Center) Missing Message | Front center ultrasonic sensor (FLC sensor) lost communication | ·
Front center ultrasonic sensor (FLC sensor) ·
Harness or connector ·
Clearance warning ECU assembly |
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
If C1AE196 is output at the same time, check C1AE196 first.
Check that the connector is properly connected to the front corner ultrasonic sensor and front center ultrasonic sensor.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1AE287 is not output | A |
| C1AE287 is output | B |
A
B
Check that the connector is properly connected to the clearance warning ECU assembly.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| C1AE487 is output | B |
| C1AE387 and C1AE487 is output | C |
| C1AE287, C1AE387 and C1AE487 is output | D |
| C1AE187, C1AE287, C1AE387 and C1AE487 is output | E |
| Only C1AE287 is output | F |
A
B
C
D
E
F
Disconnect the B20 front corner ultrasonic sensor (FL sensor) connector.
Disconnect the B22 front center ultrasonic sensor (FLC sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B20-6 (BO) - B22-5 (BI) | Always | Below 1 Ω |
| B20-1 (SO) - B22-4 (SI) | Always | Below 1 Ω |
| B20-3 (EO) - B22-2 (EI) | Always | Below 1 Ω |
| B20-6 (BO) or B22-5 (BI) - Body ground | Always | 10 kΩ or higher |
| B20-1 (SO) or B22-4 (SI) - Body ground | Always | 10 kΩ or higher |
| B20-3 (EO) or B22-2 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front center ultrasonic sensor (FLC sensor) with a known good one.
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1AE287 is not output | A |
| C1AE287 is output | B |
A
B