The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door control receiver or door control and tire pressure monitoring system receiver assembly or electrical key and tire pressure monitoring system receiver assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Tire pressure warning ECU and receiver | ·
ID Registration ·
Initialization ·
Tire Position Identification |
Tire Pressure Warning System | ( 202409,999999,_53,_083075,_0403331,RM100000002NGWW,)
|
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Tire pressure warning ECU and receiver | ·
ID Registration ·
Initialization ·
Tire Position Identification |
Tire Pressure Warning System | ( 202409,999999,_53,_083075,_0403331,RM100000002NGWW,)
|
| Door control receiver | Register a new recognition code | Wireless door lock control system (w/o Smart Entry and Start System) | ( 202409,999999,_58,_083092,_0403004,RM100000002NSB0,)
|
1.REMOVE REAR SEAT ASSEMBLY
73705
2.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
58410B
3.REMOVE DECK BOARD ASSEMBLY
58416K
4.REMOVE REAR NO. 2 FLOOR BOARD
58386
5.REMOVE REAR FLOOR FINISH PLATE
58577E
6.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
62331C
7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
Pull back the rear seat side garnish RH so that the rear door opening trim weatherstrip RH can be removed.
Use the same procedure described for the LH side.
62551F
8.REMOVE REAR SEAT SIDE GARNISH RH
Use the same procedure described for the LH side.
73708A
9.REMOVE TETHER ANCHOR BRACKET SET
58460D
10.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
64740E
11.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
62470A
12.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH
Use the same procedure described for the LH side.
897A0A
13.REMOVE DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (w/o Smart Entry and Start System)
|
Bolt |
|
Connector |
Remove the bolt.
Detach the guide and remove the door control and tire pressure monitoring system receiver assembly.
Disconnect the connector.
Do not subject the door control and tire pressure monitoring system receiver assembly to strong impacts or force, and do not drop it.
Do not reuse the door control and tire pressure monitoring system receiver assembly that has been dropped.
897B0A
14.REMOVE ELECTRICAL KEY AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (w/ Smart Entry and Start System)
Use the same procedure described for the door control and tire pressure monitoring system receiver assembly.