RM36D0EC _58 Vehicle Interior _083100 SUPPLEMENTAL RESTRAINT SYSTEMS _0400503 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89860C 1.INSTALL NO. 2 SIDE AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



c.
B555742

Attach the claw to install the No. 2 side airbag sensor assembly with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the No. 2 side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the No. 2 side airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

·

Make sure that the No. 2 side airbag sensor assembly claw is securely inserted into the body hole.




d.

Check that there is no looseness in the installed parts of the No. 2 side airbag sensor assembly.



Hide 62552F 2.INSTALL REAR SEAT SIDE GARNISH LH

Hide 58466J 4.INSTALL NO. 2 BATTERY SERVICE COVER BOARD (for HV Model)

HINT:

When removing and installing the No. 2 side airbag sensor assembly installed on the passenger side, perform this procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>BATTERY BLOWER>INSTALLATION


Hide 8. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART