LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Triple Beam Headlight)  REASSEMBLY  

Attach the wire harness clamp and install the headlight cord LH.

0,0 0,0 false

Area to Clean

Clean the application area of the No. 1 headlight protector LH shown in the illustration.

NOTICE:

Remove any remaining double-sided tape, and then clean and degrease the area.

Remove approximately 30 mm (1.18 in.) of the peeling paper from a new No. 1 headlight protector LH.

1.385,2.344 1.833,2.646 0.448,0.302 1.396,2.354 1.583,2.521 0.188,0.167 10 true *a

*a	Application Start Position
	Set in this Direction

Align the angle of the No. 1 headlight protector LH with the application start position, and then set only the part with peeling paper removed into place.

0,0 0,0 false

Remove in this Direction

Align with the curve and set only the part where the peeling type tape was removed from into place.

0,0 0,0 false

Press Area

Press the entire length of the No. 1 headlight protector LH and install it.

NOTICE:

When pressing, do not slide your finger, as doing so may stretch the part.

for Type A:

i.

0,0 0,0 false

Install in this Direction

Install the front turn signal light bulb to the bulb socket.

ii.

1.115,1.646 1.406,0.646 true 2.333,0.573 1.51,0.729 true 1.729,3.01 2.302,2.792 true 2.354,0.469 2.552,0.656 0.198,0.188 10 true *a 1.01,1.677 1.219,1.865 0.208,0.188 10 true *b 2.323,2.677 2.521,2.875 0.198,0.198 10 true *c

*a	Matchmark
*b	Unlock Position Mark
*c	Lock Position Mark
	Turn in this Direction

Align the matchmark of the bulb socket with the unlock position mark, and then turn the bulb socket clockwise until the matchmark is aligned with lock position mark and connect the bulb socket.

for Type B:

i.

Install the front turn signal light bulb to the headlight cord LH.

ii.

2.073,3.573 2.458,3.635 true 2.479,0.792 1.885,0.677 true 2.51,3.26 2.115,3.469 true 1.271,0.615 1.792,0.615 true 2.552,0.74 2.76,0.938 0.208,0.198 10 true *a 2.49,3.563 2.698,3.76 0.208,0.198 10 true *c 2.521,3.188 2.729,3.375 0.208,0.188 10 true *a 1.083,0.552 1.292,0.75 0.208,0.198 10 true *b

*a	Rib
*b	Unlock Position
*c	Lock Position
	Turn in this Direction

Align the rib of the headlight cord LH with the unlock position, and then turn the headlight cord LH clockwise until the lock position and connect the headlight cord LH.