M20C-FKS ENGINE CONTROL  ACTIVE CONTROL ENGINE MOUNT(for Front Side)  ON-VEHICLE INSPECTION  

53895B 1.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

53896B 2.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH

51441 3.REMOVE NO. 1 ENGINE UNDER COVER

51420 4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

12361A 5.INSPECT FRONT ENGINE MOUNTING INSULATOR

a.

Disconnect the vacuum hose from the front engine mounting insulator.

b.

Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.

c.

Check that there is no change in the needle movement of the vacuum pump gauge.

OK:

Vacuum pressure holds.

d.

Check that there is no fluid leakage caused by a break in the diaphragm.

e.

Connect the vacuum hose to the front engine mounting insulator.

51420 6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

51441 7.INSTALL NO. 1 ENGINE UNDER COVER

53896B 8.INSTALL FRONT FENDER FRONT SPLASH SHIELD LH

53895B 9.INSTALL FRONT FENDER FRONT SPLASH SHIELD RH