RM36D0EC _52 Drivetrain _083070 DRIVE SHAFT / PROPELLER SHAFT _0403350 REAR DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C127699N04
1.438,1.521 1.656,1.74 0.219,0.219 10 (A)

Check whether the drive shaft dimension (A) is within specification.

i.

for Gasoline Model

Length (A):
Item Length
for Torque Vectoring Differential LH Side 626.4 mm (2.05 ft.)
RH Side 611.4 mm (2.01 ft.)
except Torque Vectoring Differential 755.3 mm (2.48 ft.)



ii.

for HV Model

Length (A):
Item Length
for Type A
(SFTC made) 		LH Side 718.4 mm (2.36 ft.)
RH Side 791.4 mm (2.60 ft.)
for Type B
(GTMC made) 		LH Side 754.35 mm (2.47 ft.)
RH Side 790.45 mm (2.59 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.


If the boots are stretched or contracted, correct them.