PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  INSTALLATION  

Apply a light coat of lithium soap base glycol grease to a new O-ring.

Install the O-ring to the rear disc brake cylinder assembly.

NOTICE:

Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.

Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly LH with the 2 bolts.

Torque:

8.4 N*m (86 kgf*cm, 74 in.*lbf)

Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.

NOTICE:

·

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this work.

·

Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.