RM36D0EC _52 Drivetrain _083067 GF1A TRANSFER / 4WD / AWD _0402913 TRANSFER CASE FRONT OIL SEAL(for RH Side) A

GF1A TRANSFER / 4WD / AWD  TRANSFER CASE FRONT OIL SEAL(for RH Side)  REPLACEMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transfer case front oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Front wheel alignment adjustment
·

Perform reset memory

·

Perform acceleration sensor zero point calibration and store system information memorization


·

VSC is disabled or malfunctions

·

DTCs are output

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)

PROCEDURE

Hide 36113D 5.REMOVE TRANSFER CASE OIL SEAL RH

a.
C409432C01
2.177,2.01 2.01,2.01 2.01,2.01 1.844,1.792 true 0.99,0.479 0.75,0.333 0.75,0.333 0.667,0.333 true 2.25,1.917 2.583,2.083 0.333,0.167 10 true SST 0.438,0.271 0.656,0.438 0.219,0.167 10 false *1
*1 Transfer Case Oil Seal RH


Using SST, remove the transfer case oil seal RH from the No. 1 transfer case cover.

SST
09308-00010  

NOTICE:

Do not scratch the press-fitting surface of the transfer case oil seal RH.



Hide 36113D 6.INSTALL TRANSFER CASE OIL SEAL RH

a.

Coat the lip of a new drive shaft oil seal RH with MP grease.


b.
C409433C01
0.75,0.635 0.833,0.333 0.833,0.333 0.917,0.333 true 1.583,2.667 1.198,2.323 true 1.75,2.667 1.583,2.667 1.583,2.667 1.021,2.365 true 1.583,2.667 1.667,1.979 true 0.979,0.26 1.292,0.417 0.313,0.156 10 false *1 2.104,0.49 2.333,0.667 0.229,0.177 10 false (A) 1.833,2.583 2.177,2.781 0.344,0.198 10 true SST
*1 Transfer Case Oil Seal RH


Using SST and a hammer, tap in a new transfer case oil seal RH as shown in the illustration.

SST
09631-32020  
09950-60021  (09951-00680)
09950-70010  (09951-07360)

Drive in depth (A):

7.5 to 8.5 mm (0.296 to 0.334 in.)


NOTICE:
·

Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.

·

Do not tap the transfer case oil seal RH in too far.




Hide 10.INSPECT TRANSFER OIL LEAK