GF1A TRANSFER / 4WD / AWD  TRANSFER OIL  ON-VEHICLE INSPECTION  

Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the transfer filler plug and gasket.

2.667,0.854 2.979,1.052 0.313,0.198 10 false *a

*a	0 to 5.0 mm (0 to 0.197 in.)

Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the transfer filler plug hole.

If the result is not as specified, add transfer oil.

Oil grade:

Toyota genuine differential gear oil LX API GL-5 or equivalent

Viscosity:

SAE 75W-85

NOTICE:

·

When adding oil, pour it slowly.

·

Too much or too little oil will lead to transfer problems.

0.417,4.167 0.417,4.333 0.417,4.333 0.667,4.333 true 0.385,3.75 0.385,4 true 1,3.635 0.833,3.635 0.833,3.635 0.75,3.969 true 0.74,4.25 1.052,4.406 0.313,0.156 10 false *a 0.302,3.552 0.615,3.708 0.313,0.156 10 false *b 2.094,3.344 2.406,3.5 0.313,0.156 10 false *c 1.063,3.563 1.375,3.719 0.313,0.156 10 false SST

*a	10 mm Straight Hexagon Wrench
*b	10 mm Union Nut Wrench
*c	Fulcrum Length

Using SST, 10 mm straight hexagon wrench and union nut wrench, install a new gasket into the transfer filler plug, and then install the transfer filler plug.

SST

09961-00950  

Torque:

Specified tightening torque : 39 N*m (398 kgf*cm, 29 ft.*lbf)

HINT:

·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION201910,999999,_V1,_083040,_0402303,RM100000001JHCH,

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + SST (fulcrum length of 150 mm (5.906 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 19.9 N*m (203 kgf*cm, 15 ft.*lbf)