RM38N0EC _58 Vehicle Interior _111842 POWER OUTLETS (INT) _0586678 WIRELESS CHARGING SYSTEM(for SFTM Made) J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM(for SFTM Made)  Wireless Charger Power Source Circuit  


DESCRIPTION

This is the power source circuit for the mobile wireless charger cradle assembly.

WIRING DIAGRAM

E470738E02
2.74,0.833 3.813,1.031 1.073,0.198 10 false ECU-ACC 4.375,2 4.99,2.198 0.615,0.198 10 false E161 4.375,2.177 7.104,2.625 2.729,0.448 10 false Mobile Wireless Charger Cradle Assembly 0.5,0.635 1.583,1.083 1.083,0.448 10 false from ACC Relay 4.396,0.531 4.552,0.729 0.156,0.198 10 false 1 4.625,0.635 5.083,0.833 0.458,0.198 10 false ACC 4.615,1.448 5.229,1.646 0.615,0.198 10 false PGND 4.396,1.333 4.552,1.531 0.156,0.198 10 false 3

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY POWER SOURCE)
a.

Disconnect the E161 mobile wireless charger cradle assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(E161)Location & Routing

Click Connector(E161)Instrument Panel>Instrument Panel Wire / Radio Wiring Sub-Assy / Telephone Computer Wire>Mobile Wireless Charger Cradle Assembly

E161-3 (PGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(E161)Location & Routing

Click Connector(E161)Instrument Panel>Instrument Panel Wire / Radio Wiring Sub-Assy / Telephone Computer Wire>Mobile Wireless Charger Cradle Assembly

E161-1 (ACC) - Body ground Ignition switch ACC 11 to 14 V


Result:
Proceed to
OK
NG




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR