RM38N0EC _57 Power Source / Network _111829 NETWORKING _0505700 CXPI COMMUNICATION SYSTEM L

NETWORKING  CXPI COMMUNICATION SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting and reconnecting the auxiliary battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE


HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART



PRECAUTION FOR POWER DISTRIBUTION BOX ASSEMBLY


a.

Do not remove or install the power distribution box assembly with the negative (-) auxiliary battery terminal connected.

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE




b.

Make sure that the power distribution box assembly is not exposed to water, as it is not waterproof.


c.

Some loads are connected to circuits with dedicated overcurrent protection. Therefore, do not use parts other than those specified for the vehicle.


d.

When replacing the power distribution box assembly, the system may not operate normally if the same part number is not used.


e.

Check that systems are operating normally before proceeding with troubleshooting.