DATA LIST
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front Left Seat Heat Sensor | LH side front seat heater temperature | 0 to 655.35 kohm | 7.37 to 9.01 ohm | Refreshing seat switch (driver seat) ON |
| Front Right Seat Heat Sensor | RH side front seat heater temperature | 0 to 655.35 kohm | 7.37 to 9.01 ohm | Refreshing seat switch (front passenger seat) ON |
| Front Right Seat Heater | RH side front seat heater condition | OFF or ON | OFF: RH side front seat heater does not operate
ON: RH side front seat heater operate |
- |
| Front Left Seat Heater | LH side front seat heater condition | OFF or ON | OFF: LH side front seat heater does not operate
ON: LH side front seat heater operate |
- |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Right Seat Heater | Front seat RH side seat heater operation | OFF or ON | - |
| Front Left Seat Heater | Front seat LH side seat heater operation | OFF or ON | - |