☰ Toyota Venza☰ فهرستEngine / Hybrid System › M20C-FKS, M20D-FKS ENGINE CONTROL › ACTIVE CONTROL ENGINE MOUNT(for Rear Side)
RM38N0EC
_51
Engine / Hybrid System
_111785
M20C-FKS, M20D-FKS ENGINE CONTROL
_0503270
ACTIVE CONTROL ENGINE MOUNT(for Rear Side)
G
M20C-FKS, M20D-FKS ENGINE CONTROL ACTIVE CONTROL ENGINE MOUNT(for Rear Side) ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
- HINT:
-
Refer to Problem Symptoms Table.
PROCEDURE
51420
1.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
12371A
2.INSPECT REAR ENGINE MOUNTING INSULATOR
a.
Disengage the 2 clamps to separate the vacuum hose.
b.
Disconnect the vacuum hose.
c.
Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.
d.
Check that there is no change in the needle movement of the vacuum pump gauge.
- OK:
Vacuum pressure holds.
e.
Check that there is no fluid leakage caused by a break in the diaphragm.
f.
Connect the vacuum hose.
g.
Engage the 2 clamps to install the vacuum hose.
51420
3.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY