RM38N0EC _54 Brake _111818 PARKING BRAKE _0502910 ELECTRIC PARKING BRAKE ACTUATOR A

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 46310C 1.INSTALL PARKING BRAKE ACTUATOR SEAL

a.

Apply a light coat of lithium soap base glycol grease to a new parking brake actuator seal.


b.

Install the parking brake actuator seal to the rear disc brake cylinder assembly.

NOTICE:

Make sure to replace the parking brake actuator seal with a new one when installing the parking brake actuator assembly.



Hide 46310B 2.INSTALL PARKING BRAKE ACTUATOR ASSEMBLY

a.

Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 890C0A 3.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

a.

Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.

NOTICE:
·

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this work.

·

Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.