RM38N0EC
_56
Audio / Visual / Telematics
_111822
AUDIO / VIDEO
_0500663
NOISE FILTER
G
AUDIO / VIDEO NOISE FILTER ON-VEHICLE INSPECTION
PROCEDURE
86011V
1.INSPECT RADIO SETTING CONDENSER
a.
With the radio setting condenser installed, check that there is no looseness or other abnormalities.
b.
1.01,0.479 1.594,0.479
false
0.906,0.406 1.063,0.604
0.156,0.198
10
false
1
0.146,0.146 0.458,0.344
0.313,0.198
10
false
*a
| *a | Radio Setting Condenser |
Measure the resistance of the radio setting condenser according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 - Body ground ·Ignition switch off
·Window Defogger turned off
Below 1 Ω
c.
Remove the bolt.
d.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
e.
2.083,1.583 2.542,1.427
false
1.344,1.594 0.813,1.427
false
2.563,1.333 2.677,1.49
0.115,0.156
11
false
3
0.708,1.313 0.823,1.469
0.115,0.156
10
false
2
0.063,0.073 0.271,0.229
0.208,0.156
10
false
*a
| *a | Radio Setting Condenser |
Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 2 - 3 ·Ignition switch off
·Window Defogger turned off
10 kΩ or higher
- Standard Voltage:
Tester Connection Condition Specified Condition 2 - Body ground ·Ignition switch on (IG)
·Window Defogger turned off
Below 1 V 2 - Body ground ·Ignition switch on (IG)
·Window Defogger turned on
11 to 14 V