PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SWITCH  INSPECTION  

1.01,1.906 1.177,1.906 1.177,1.906 1.417,1.49 false 2.542,1.948 2.375,1.948 2.375,1.948 2.021,1.49 false 0.115,0.094 0.427,0.25 0.313,0.156 10 false *a 0.854,1.823 1.167,1.979 0.313,0.156 10 false D 2.615,1.865 2.927,2.021 0.313,0.156 10 false E

*a	Component without harness connected (Panoramic View Monitor Switch)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
5 (D) - 2 (E)	Panoramic view monitor switch pushed	Below 1 Ω
	Panoramic view monitor switch not pushed	10 kΩ or higher

If the result is not as specified, replace the panoramic view monitor switch.

Check that the switch illumination illuminates.

i.

0.875,1.99 1.042,1.99 1.042,1.99 1.229,1.49 false 2.573,1.958 2.406,1.958 2.406,1.958 2.198,1.49 false 0.115,0.094 0.427,0.25 0.313,0.156 10 false *a 0.552,1.906 0.927,2.063 0.375,0.156 10 false ILL+ 2.635,1.865 3.042,2.083 0.406,0.219 10 false ILL-

*a	Component without harness connected (Panoramic View Monitor Switch)

Apply auxiliary battery voltage to the panoramic view monitor switch and check that the switch illumination illuminates.

OK:

Connection	Specified Condition
Auxiliary battery positive (+) → Terminal 6 (ILL+) Auxiliary battery negative (-) → Terminal 1 (ILL-)	Illuminates

If the result is not as specified, replace the panoramic view monitor switch.