DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Read the Data List.
| Tester Display |
|---|
| Total Distance Traveled |
| Total Distance Traveled - Unit |
| IG2 SW/IGR SW |
| IG1 SW/IGP SW |
| ACC SW |
| +B Voltage |
| Tester Display | Measurement Item | Range | Normal Condition |
|---|---|---|---|
| Total Distance Traveled | Total distance traveled | Min.: 0 km (0 mile), Max.: 16777215 km (10425361 mile) | - |
| Total Distance Traveled - Unit | Total Distance Traveled unit | km or mile | - |
| IG2 SW/IGR SW | Ignition switch ON signal (IGR terminal) | OFF or ON | OFF: Ignition switch ACC or off
ON: Ignition switch ON |
| IG1 SW/IGP SW | Ignition switch ON signal (IGP terminal) | OFF or ON | OFF: Ignition switch ACC or off
ON: Ignition switch ON |
| ACC SW | Ignition switch ACC signal (ACC terminal) | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ACC or ON |
| +B Voltage | Battery voltage (BATT terminal) | Over 8 V or Under 8 V | Over 8 V: Battery voltage 8 V or higher
Under 8 V: Battery voltage below 8 V |