LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  

1.188,1.583 1.438,1.229 true 2.208,1.583 1.948,1.229 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 1.094,1.625 1.406,1.781 0.313,0.156 10 false TB 2.198,1.625 2.51,1.781 0.313,0.156 10 false E

*a	Component without harness connected (Hazard Warning Signal Switch Assembly)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
6 (TB) - 3 (E)	Hazard warning switch off	10 kΩ or higher
	Hazard warning switch on	Below 1 Ω

If the result is not as specified, replace the hazard warning signal switch assembly.

1.021,1.583 1.271,1.229 true 2.385,1.573 2.125,1.219 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 0.938,1.604 1.25,1.76 0.313,0.156 10 false ILL+ 2.344,1.604 2.656,1.76 0.313,0.156 10 false ILL-

*a	Component without harness connected (Hazard Warning Signal Switch Assembly)

Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:

Measurement Condition	Condition	Specified Condition
Auxiliary battery positive (+) → Terminal 7 (ILL+) Auxiliary battery negative (-) → Terminal 2 (ILL-)	Always	Switch illumination illuminates

If the result is not as specified, replace the hazard warning signal switch assembly.