K120 / K120F / K121 / K121F CVT CONTINUOUSLY VARIABLE TRANSAXLE FLUID REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during CVT fluid replacement are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of CVT fluid | Air bleed the oil pump with motor assembly | Stop and Start System | ( 202111,999999,_51,_111803,_0509671,RM1000000020651,)
|
| ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly | (202111,202303,_52,_111806,_0499726,RM100000001YZJA,202303,999999,_52,_111806,_0584611,RM1000000029R1M,)
|
PROCEDURE
51420
1.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
53737B
2.REMOVE FRONT FENDER APRON SEAL LH
3.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE FLUID
4.ADD SPECIFIED AMOUNT OF FLUID
5.ADJUST FLUID TEMPERATURE (when Using the GTS)
6.ADJUST FLUID TEMPERATURE (when Not Using the GTS)
7.ADJUST FLUID LEVEL
8.PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET
- NOTICE:
-
If approximately 50% or more of the CVT fluid has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.
9. REBUILD WORK
53737B
10.INSTALL FRONT FENDER APRON SEAL LH
51420
11.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY