WINDOW / GLASS POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for the RH side and LH side.
·The following procedure is for the LH side.
PROCEDURE
85720D
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
- NOTICE:
-
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
- Torque:
- 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- HINT:
-
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
68102
3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
4.INSTALL HOLE PLUG
67832
5.INSTALL FRONT DOOR SERVICE HOLE COVER
67831D
6.INSTALL FRONT DOOR SERVICE HOLE COVER CLIP
67602
7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
74222A
8.INSTALL FRONT DOOR ARMREST COVER
69278E
9.INSTALL FRONT DOOR INSIDE HANDLE BEZEL
10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M20C-FKS, M20D-FKS: Click hereGeneral>MAINTENANCE>M20C-FKS, M20D-FKS BATTERY>INSTALLATION202111,999999,_V1,_112220,_0503321,RM100000001ZE56_01_0015,
for A25D-FXS, A25F-FXS: Click hereGeneral>MAINTENANCE>A25D-FXS, A25F-FXS AUXILIARY BATTERY>INSTALLATION202111,999999,_V1,_112220,_0503322,RM100000001ZE59_01_0015,
65351A
11.INSTALL BATTERY HOLE COVER (for HV Model)
58416K
12.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
13. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
- HINT:
-
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
14.INITIALIZE POWER WINDOW CONTROL SYSTEM
15.INSPECT POWER WINDOW OPERATION