73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Attach the claw and hook to install the lower No. 1 instrument panel airbag assembly.
Install the 2 bolts.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector:
Check that there is no looseness in the lower No. 1 instrument panel airbag assembly.
55480D
2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55545
3.INSTALL FUSE BOX OPENING COVER
77306
4.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for Gasoline Model)
53601
5.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55606
6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112
7.INSTALL COWL SIDE TRIM BOARD LH
67914B
8.INSTALL FRONT DOOR SCUFF PLATE LH
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
10. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
11. PERFORM DIAGNOSTIC SYSTEM CHECK
12.CHECK SRS WARNING LIGHT