45130
1.INSTALL HORN BUTTON ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Support the horn button assembly with one hand.
Connect the horn connector and attach the wire harness clamp.
When installing a new spiral cable sub-assembly:
| *a | Airbag Connector |
Remove the airbag connector from the wire harness clamp.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to connect the connectors to each corresponding color.
Make sure the lock button is securely locked.
Refer to How to Connect or Disconnect Airbag Connector:
Set the horn button assembly to the steering wheel assembly.
Check that the airbag wire harness and horn wire harness are not pinched.
| *a | Upper Pin |
| *b | Lower Pin |
Press the horn button assembly with both hands to attach the upper pin to the upper spring.
Press the horn button assembly with both hands to attach the lower pin to the lower spring.
After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.
2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
3. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
4.INSPECT HORN BUTTON ASSEMBLY
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
5. PERFORM DIAGNOSTIC SYSTEM CHECK
6.CHECK SRS WARNING LIGHT