The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front wheel alignment adjustment | 1.
Perform "Reset Memory" 2.
Perform "Calibration" |
·
DTCs are stored ·
ABS warning light illuminates ·
Brake warning light / yellow (minor malfunction) illuminates ·
Slip indicator light illuminates ·
VSC disabled or malfunctions |
( 202304,999999,_54,_083077,_0401811,RM1000000029TH7,)
|
| Suspension, tires, etc. | Parking assist ECU initialization | Panoramic view monitor system | ( 202304,999999,_56,_083082,_0586733,RM1000000029R9G,)
|
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front wheel alignment adjustment | 1.
Perform "Reset Memory" 2.
Perform acceleration sensor zero point calibration and store system information memorization |
·
VSC is disabled or malfunctions ·
DTCs are output ·
Slip indicator light illuminates ·
ABS warning light illuminates |
( 202304,999999,_54,_083077,_0402316,RM100000002AG8P,)
|
| Suspension, tires, etc. | Parking assist ECU initialization | Panoramic view monitor system | ( 202304,999999,_56,_083082,_0586733,RM1000000029R9G,)
|
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
53896B
2.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
53895B
3.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
51420
5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
6.REMOVE ENGINE UNDER COVER HEAT INSULATOR (for A25B-FXS)
7.REMOVE ENGINE UNDER COVER HEAT INSULATOR (for A25D-FXS)
8.REMOVE ENGINE UNDER COVER HEAT INSULATOR (for A25F-FXS)
58166A
9.REMOVE FRONT FLOOR COVER LH (for LH Side)
58166A
10.REMOVE FRONT FLOOR COVER RH (for RH Side)
53737D
11.REMOVE FRONT FENDER APRON SEAL LH (for LH Side)
53736E
12.REMOVE FRONT FENDER APRON SEAL RH (for RH Side)
48069
13.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front engine support member sub-assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.