Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87961
1.REMOVE OUTER MIRROR LH
0,0 0,0
false
|
Push in this Direction |
|
Protective Tape |
Push the upper part of the outer mirror LH surface and tilt it.
Apply protective tape to the areas shown in the illustration.
0,0 0,0
false
|
Push in this Direction |
|
Protective Tape |
Push down the lower part of the outer mirror LH surface and tilt it.
Apply protective tape as shown in the illustration.
|
Move in this Direction |
|
Protective Tape |
Push the upper part of the outer mirror LH surface and tilt it.
Using moulding remover D, detach the claw.
|
Move in this Direction |
|
Protective Tape |
Push down the lower part of the outer mirror LH surface and tilt it.
Using moulding remover D, detach the claw and remove the outer mirror LH.
w/ Mirror Heater:
Disconnect the mirror heater connector.
Do not raise the claw higher than is necessary as it will damage the claw of the terminal.
If the claw of the connector is damaged, replace the outer mirror LH with a new one.
If there is damage to the wire harness or an open circuit has occurred, replace the outer rear view mirror assembly LH with a new one.
w/ Blind Spot Monitor System:
Disconnect the connector.