M20D-FKS FUEL  FUEL PRESSURE SENSOR  INSPECTION  

1.802,0.771 1.344,0.333 1.344,0.333 1.177,0.333 true 1.99,0.771 2.406,0.333 2.406,0.333 2.573,0.333 true 0.135,0.135 0.448,0.292 0.313,0.156 10 false *a 1.521,1.844 1.833,2 0.313,0.156 10 false *b 0.99,0.26 1.302,0.458 0.313,0.198 10 false E2 2.625,0.271 2.938,0.469 0.313,0.198 10 false VC

*a	Component without harness connected (No. 2 Fuel Pressure Sensor)
*b	Voltage Applied between Terminals

Apply 5 V between terminals 1 (VC) and 3 (E2).

NOTICE:

·

Be careful when connecting the leads, as the No. 2 fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (VC) or 3 (E2).

HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.

1.615,1.156 1.313,1.667 1.313,1.667 1.313,1.833 true 1.729,1.167 1.99,1.667 1.99,1.667 1.99,1.833 true 0.125,0.125 0.438,0.281 0.313,0.156 10 false *a 1.25,1.865 1.563,2.063 0.313,0.198 10 false E2 1.885,1.865 2.198,2.063 0.313,0.198 10 false PFL

*a	Component without harness connected (No. 2 Fuel Pressure Sensor)

Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
2 (PFL) - 3 (E2)	Pressure not applied to No. 2 fuel pressure sensor	Approximately 0.56 to 0.94 V*

*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the No. 2 fuel pressure sensor.