RM36D0EC _51 Engine / Hybrid System _083063 M20D-FKS COOLING _0403603 WATER PUMP A

M20D-FKS COOLING  WATER PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16032 1.INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.

Install a new gasket to the engine water pump assembly (water inlet housing).

HINT:

Be sure to clean the contact surfaces.



b.

Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the engine water pump assembly (water inlet housing) connector.


e.

Connect the sensor wire connector.