RM36D0EC
_59
Vehicle Exterior
_083096
LIGHTING (EXT)
_0402641
HAZARD WARNING SWITCH
G
LIGHTING (EXT) HAZARD WARNING SWITCH INSPECTION
PROCEDURE
84330
1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
a.
1.26,1.854 1.469,1.271
true
1.75,1.854 1.958,1.271
true
0.094,0.083 0.406,0.24
0.313,0.156
10
false
*a
1.156,1.875 1.615,2.073
0.458,0.198
10
false
TB
1.688,1.885 2.146,2.083
0.458,0.198
10
false
E
| *a | Component without harness connected
(Hazard Warning Signal Switch Assembly) |
Inspect the hazard warning signal switch.
i.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Switch Condition Specified Condition If the result is not as specified, replace the hazard warning signal switch assembly.
5 (TB) - 2 (E) Hazard warning signal switch off 10 kΩ or higher Hazard warning signal switch on Below 1 Ω
b.
1.073,1.854 1.281,1.271
true
1.906,1.854 2.115,1.271
true
0.094,0.083 0.406,0.24
0.313,0.156
10
false
*a
0.969,1.885 1.427,2.083
0.458,0.198
10
false
ILL+
1.823,1.885 2.281,2.083
0.458,0.198
10
false
ILL-
| *a | Component without harness connected
(Hazard Warning Signal Switch Assembly) |
Check the illumination.
i.
Apply auxiliary battery voltage to the connector and check the illumination conditions.
- OK:
Auxiliary Battery Connection Specified Condition If the result is not as specified, replace the hazard warning signal switch assembly.
Auxiliary battery positive (+) → 6 (ILL+)
Auxiliary battery negative (-) → 1 (ILL-)Illuminates