RM36D0EC _51 Engine / Hybrid System _083058 M20D-FKS ENGINE CONTROL _0401817 CAMSHAFT TIMING CONTROL MOTOR G

M20D-FKS ENGINE CONTROL  CAMSHAFT TIMING CONTROL MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 13090D 1.INSPECT CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY

a.

Check Rotation Direction Signal:

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / VVT-iE Motor Direction Bank 1.

Powertrain > Engine > Data List
Tester Display
VVT-iE Motor Direction Bank 1
50003 372 557

v.

According to the display on the GTS, read the Data List.

Specified Condition:
GTS Display Condition Specified Condition
VVT-iE Motor Direction Bank 1 Ignition switch off → Ignition switch on Backward


HINT:

If the result is not as specified, inspect the cam timing control motor with EDU assembly and wire harness.




b.

Check VVT Change Angle:

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.


v.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT-iE Opening Angle Bank 1 / Data List / Intake VVT Change Angle Bank 1 and Intake VVT Target Angle Bank 1.

Powertrain > Engine > Active Test
Active Test Display
Control the VVT-iE Opening Angle Bank 1
Data List Display
Intake VVT Change Angle Bank 1
Intake VVT Target Angle Bank 1
50004 372 57 397,300

vi.

Read the Data List while performing the Active Test with the engine idling.

Specified Condition:
Active Test Movement Order Difference between "Intake VVT Change Angle Bank 1" and "Intake VVT Target Angle Bank 1"
0 deg → 10 deg → 20 deg → 40 deg → 0 deg → 10 deg → END Within 4 DegFR


HINT:

If the result is not as specified, inspect the cam timing control motor with EDU assembly and camshaft timing gear assembly.