M20D-FKS ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID  INSPECTION  

0.122,0.095 0.323,0.262 0.201,0.167 10 *a

*a	Component without harness connected (Cam Timing Oil Control Solenoid Assembly)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	0°C (32°F)	6.3 to 7.3 Ω
	20°C (68°F)	6.9 to 7.9 Ω
	40°C (104°F)	7.4 to 8.6 Ω

If the result is not as specified, replace the cam timing oil control solenoid assembly.

1.198,1.344 1.583,1.344 false 1.188,2.229 1.573,2.229 false 0.125,0.333 0.438,0.49 0.313,0.156 10 false *a 0.146,2.542 0.458,2.698 0.313,0.156 10 false *b 1.021,1.281 1.333,1.438 0.313,0.156 10 false *c 1.01,2.156 1.323,2.313 0.313,0.156 10 false *c 2.25,1.208 2.563,1.365 0.313,0.156 10 false A 2.24,2.26 2.552,2.417 0.313,0.156 10 false B

*a	Shaft Side Facing Down
*b	Shaft Side Facing Up
*c	Shaft

Using a vernier caliper, measure length (A) and (B) with the shaft of the cam timing oil control solenoid assembly set in the respective positions shown in the illustration.

NOTICE:

Do not apply battery voltage to the terminals of the cam timing oil control solenoid assembly.

HINT:

If the shaft does not extend under its own weight, extend the shaft with your fingers.