RM3660EC
_58
Vehicle Interior
_080766
POWER OUTLETS (INT)
_0611796
WIRELESS CHARGING SYSTEM
J
POWER OUTLETS (INT) WIRELESS CHARGING SYSTEM Wireless Charger Power Source Circuit
DESCRIPTION
This is the power source circuit for the mobile wireless charger cradle assembly.
WIRING DIAGRAM
2.74,0.833 3.813,1.031
1.073,0.198
10
false
ECU-ACC
4.375,2 4.99,2.198
0.615,0.198
10
false
I244
4.375,2.177 7.104,2.625
2.729,0.448
10
false
Mobile Wireless Charger Cradle Assembly
0.5,0.635 1.583,1.083
1.083,0.448
10
false
from ACC Relay
4.396,0.531 4.552,0.729
0.156,0.198
10
false
1
4.625,0.635 5.083,0.833
0.458,0.198
10
false
ACC
4.615,1.448 5.229,1.646
0.615,0.198
10
false
PGND
4.396,1.333 4.552,1.531
0.156,0.198
10
false
3
CAUTION / NOTICE / HINT
- NOTICE:
-
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
1.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY POWER SOURCE)
a.
Disconnect the I244 mobile wireless charger cradle assembly connector.
b.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition I244-3 (PGND) - Body ground Always Below 1 Ω
c.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection Switch Condition Specified Condition I244-1 (ACC) - Body ground Ignition switch on (ACC) 11 to 14 V
- Result:
Proceed to OK NG
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR