Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
DATA LIST FOR AIRBAG SENSOR WITH ECU ASSEMBLY
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Right side Buckle SW | Front seat belt buckle switch RH | Unset: Seat belt is not fastened
Set: Seat belt is fastened NG: Data is not determined |
Unset/Set | - |
| Display Type Information | Display type information | LR: Display is indicated by LH/RH
DP: Display is indicated by Driver/Passenger |
LR | - |
| Number of Past DTC | Number of past DTC | Min.: 0, Max.: 255 | 0 | - |