RM3660EC _51 Engine / Hybrid System _080759 NR Series STARTING _0392365 STARTER A

NR Series STARTING STARTER INSTALLATION

PROCEDURE

Hide Display 28100 1.INSTALL STARTER ASSEMBLY

Install the starter assembly with the 2 bolts.

Torque:: 46 N*m (469 kgf*cm, 34 ft.*lbf)

Connect the wire harness to terminal 30 with the nut.

Torque:: 9.8 N*m (100 kgf*cm, 87 in.*lbf)

Close the terminal cap.

Connect the starter assembly connector.

Engage the wire harness clamp.

Connect the compressor assembly with pulley connector and engine oil level sensor connector.

Hide Display 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.

NOTICE:: ·

Make sure the claw makes a click sound, indicating that it fits tightly.

·

Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.

Hide Display 51410 3.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Click hereEngine / Hybrid System>NR Series (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION202304,999999,_51,_080739,_0391935,RM100000002BCNA_01_0452,

Hide Display 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>NR Series BATTERY>INSTALLATION202304,999999,_V1,_080956,_0392375,RM100000002BCCN_03_0002,

Hide Display 5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:: When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.; Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART202304,999999,_V1,_143216,_0598315,RM100000002B3MJ,