RM3660EC _52 Drivetrain _080786 AXLE AND DIFFERENTIAL _0392503 REAR AXLE HUB(for Double Wishbone Type Suspension with Electric Parking Brake) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Double Wishbone Type Suspension with Electric Parking Brake)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
for HV Model
·

When removing or installing the rear disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 890C0A 6.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

a.

Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.


b.

Connect the No. 2 parking brake wire assembly connector to the rear axle hub and bearing assembly.