LIGHTING (EXT) LIGHTING SYSTEM(for NR Series Engine) OPERATION CHECK
AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
- NOTICE:
-
Make sure that the customize settings are set to default when performing the automatic light control system operation check.
Turn the ignition switch to ON.
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor.
Check that the taillights and low beam headlights come on.
Uncover the automatic light control sensor.
Check that the low beam headlights and taillights turn off.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK
- NOTICE:
-
Make sure that the customize settings are set to default when performing the light auto turn-off system operation check.
Close all of the doors.
Turn the ignition switch to ON.
Turn the taillights, low beam headlights, high beam headlights, front fog lights* and rear fog lights on.
Turn the ignition switch off.
Open the driver door.
Check that all of the lights turn off immediately.
*: w/ Front Fog Light
DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK
Start the engine.
Turn the light control switch to the AUTO position (with the low beam headlights not turned on via the automatic light control system).
Release the parking brake.
Check that the daytime running lights come on.
MANUAL HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK
Turn the ignition switch to ON.
Turn the headlights on.
Turn the headlight leveling switch to "0".
Check that the headlight beam level changes when the headlight leveling switch is operated.
AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK
| *a | Automatic High Beam Indicator Light on Combination Meter Assembly |
| *b | Auto High Beam Switch Indicator |
Check the operation of the automatic high beam indicator light.
Turn the ignition switch to ON.
Turn the light control switch to the AUTO or head position.
Move the dimmer switch to the high position.
Press the auto high beam switch (indicator illuminates).
- HINT:
-
If the auto high beam switch is turned on when the light control switch is not in the AUTO or head position, or the dimmer switch is not in the high position, "To Activate Automatic High Beam, Switch Headlights to High Beam" will be displayed on the multi-information display.
Check that the automatic high beam indicator illuminates.
- NOTICE:
-
If the forward recognition camera cannot correctly recognize the view ahead due to bad weather (dense fog, etc.) or if dirt, etc., is obstructing the windshield glass, the automatic high beam indicator in the combination meter assembly may not illuminate and the automatic high beam system may not operate.
Check the operation of the automatic high beam function.
At night, when driving the vehicle with the automatic high beam system in standby mode, check that the high beams automatically turn on after a short delay when all of the following conditions are met:
The vehicle speed is more than approximately 30 km/h (19 mph).
The area in front of the vehicle is dark.
There are no oncoming vehicles with headlights on.
There are no preceding vehicles with taillights on.
There are few streetlights along the street ahead.
At night, when driving the vehicle with the high beams turned on by the automatic high beam system, check that the automatic high beam system turns off the high beams and returns to standby mode when any of the following conditions are met:
The vehicle speed is less than approximately 25 km/h (16 mph).
The level of ambient light is higher than a specified threshold.
There are oncoming vehicles with headlights on.
There are preceding vehicles with taillights on.
Light from streetlights ahead is higher than a specified threshold.