RM3660EC _51 Engine / Hybrid System _080777 NR Series ENGINE CONTROL _0392334 CAMSHAFT OIL CONTROL VALVE(for Exhaust Side) A

NR Series ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Exhaust Side)  INSTALLATION  


PROCEDURE

Hide 13523F 1.INSTALL CAMSHAFT TIMING GEAR BOLT

a.

Make sure that the No. 1 cylinder is at the TDC/compression.

HINT:

Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly.



b.
A352541

Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.


c.

While holding the crankshaft pulley, install the camshaft timing gear bolt.

Torque:
95 N*m (969 kgf*cm, 70 ft.*lbf)

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

Do not use an impact wrench.

·

If there is any abnormal resistance when installing the camshaft timing gear bolt, loosen it and make sure that the No. 1 cylinder is at TDC/compression, and then install the camshaft timing gear bolt again.