86011A
1.INSPECT RADIO SETTING CONDENSER
With the radio setting condenser installed, check that there is no looseness or other abnormalities.
| *a | Radio Setting Condenser |
Measure the resistance of the radio setting condenser according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
*1: for HV Model *2: for Gasoline Model |
||
| 1 - Body ground | ·
Power switch off*1 ·
Ignition switch off*2 ·
Window Defogger turned off ·
High mounted stop light off |
Below 1 Ω |
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
| *a | Radio Setting Condenser |
Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
*1: for HV Model *2: for Gasoline Model |
||
| 1 - 2 | ·
Power switch off*1 ·
Ignition switch off*2 ·
Window Defogger turned off ·
High mounted stop light off |
10 kΩ or higher |
| 1 - 3 | 10 kΩ or higher | |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
*1: for HV Model *2: for Gasoline Model |
||
| 2 - Body ground | ·
Power switch on (IG)*1 ·
Ignition switch On*2 ·
Window Defogger turned off |
Below 1 V |
| 3 - Body ground | ·
Power switch on (IG)*1 ·
Ignition switch On*2 ·
High mounted stop light off |
Below 1 V |
| 2 - Body ground | ·
Power switch on (IG)*1 ·
Ignition switch On*2 ·
Window Defogger turned on |
11 to 14 V |
| 3 - Body ground | ·
Power switch on (IG)*1 ·
Ignition switch On*2 ·
High mounted stop light on |
11 to 14 V |