RM3660EC _52 Drivetrain _080728 K313 CVT _0392271 OIL PRESSURE SENSOR A

K313 CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.

Apply Toyota Genuine CVT fluid FE to the O-ring of the oil pressure sensor.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.



b.
C400266C01
2.177,0.427 2.615,0.25 true 2.698,0.146 3.021,0.375 0.323,0.229 10 true SST 2.021,1.688 2.271,1.896 0.25,0.208 10 true *a
*a Torque Wrench Fulcrum Length


Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

SST
09326-22011  

Torque:
Specified Tightening Torque : 20.6 N*m (210 kgf*cm, 15 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 50 mm (1.97 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 16.1 N*m (164 kgf*cm, 12 ft.*lbf)




c.

Connect the oil pressure sensor connector.


Hide 2.INSPECT FOR OIL LEAK