RM3660EC _59 Vehicle Exterior _080767 WIPER / WASHER _0391511 WIPER AND WASHER SYSTEM(for HV Model) U

WIPER / WASHER  WIPER AND WASHER SYSTEM(for HV Model)  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

for Main Body: Body Electrical / Main Body / Data List.


ii.

for Steering Angle Sensor: Chassis / Steering Angle Sensor / Data List.



e.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Communication Wiper Module Connection status between windshield wiper relay assembly and main body ECU (multiplex network body ECU) STOP or OK STOP: Not Connected
OK: Connected 		DTCs are stored if a malfunction occurs in the CXPI communication.
Chassis > Steering Angle Sensor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Wiper OFF Switch Front wiper switch OFF position signal OFF or ON OFF: Front wiper switch not in OFF position
ON: Front wiper switch in OFF position 		-
Wiper Auto/Int Switch Front wiper switch INT position signal OFF or ON OFF: Front wiper switch not in INT position
ON: Front wiper switch in INT position 		-
Wiper Lo Switch Front wiper switch LO position signal OFF or ON OFF: Front wiper switch not in LO position
ON: Front wiper switch in LO position 		-
Wiper Hi Switch Front wiper switch HI position signal OFF or ON OFF: Front wiper switch not in HI position
ON: Front wiper switch in HI position 		-
Wiper Mist Switch Front wiper switch MIST position signal OFF or ON OFF: Front wiper switch not in MIST position
ON: Front wiper switch in MIST position 		-
Washer Switch Washer switch Fr WASH position signal OFF or ON OFF: Washer switch not in Fr WASH position
ON: Washer switch in Fr WASH position 		-
Rear Wiper INT Switch Rear wiper switch Rr INT position signal OFF or ON OFF: Rear wiper switch not in Rr INT position
ON: Rear wiper switch in Rr INT position 		Although this item is displayed on the GTS, it is not applicable to this vehicle.
Rear Wiper ON Switch Rear wiper switch Rr ON position signal OFF or ON OFF: Rear wiper switch not in Rr ON position
ON: Rear wiper switch in Rr ON position 		Although this item is displayed on the GTS, it is not applicable to this vehicle.
Rear Washer Switch Washer switch Rr WASH position signal OFF or ON OFF: Washer switch not in Rr WASH position
ON: Washer switch in Rr WASH position 		Although this item is displayed on the GTS, it is not applicable to this vehicle.
Intermittent Time Volume (Shortest) Intermittent time adjustment switch P4 position signal OFF or ON OFF: Intermittent time adjustment switch in P4 position
ON: Washer switch in P4 position 		*
Intermittent Time Volume (Shorter) Intermittent time adjustment switch P3 position signal OFF or ON OFF: Intermittent time adjustment switch not in P3 position
ON: Washer switch in P3 position 		*
Intermittent Time Volume (Longer) Intermittent time adjustment switch P2 position signal OFF or ON OFF: Intermittent time adjustment switch not in P2 position
ON: Washer switch in P2 position 		*
Intermittent Time Volume (Longest) Intermittent time adjustment switch P1 position signal OFF or ON OFF: Intermittent time adjustment switch not in P1 position
ON: Washer switch in P1 position 		*

*: Refer to Inspection for each position of the switch. (w/ Intermittent Time Adjustment Switch)

Click hereVehicle Exterior>WIPER / WASHER>WIPER SWITCH>INSPECTION




ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Wiper Power Relay Function to operate the WIPER relay OFF or ON -
Front Washer Relay Function to operate the windshield washer motor and pump assembly (Front) OFF or ON -
Front Wiper Lo Operation Function to operate the windshield wiper motor assembly in LO OFF or ON -
Front Wiper Hi Operation Function to operate the windshield wiper motor assembly in HI OFF or ON -