1.PRECAUTION WHEN REMOVING/INSTALLING INVERTER WITH CONVERTER ASSEMBLY
Do not push down or apply excessive force to the inverter with converter assembly.
Be careful not to injure yourself on the edges of the inverter with converter assembly when performing work.
Observe the following in order to prevent entry of foreign matter:
Do not allow foreign matter such as grease, oil or water to adhere to the inside of the inverter with converter assembly.
Do not use air tools in areas other than specified to prevent entry of dust.
Prevent wind from blowing through the workshop to prevent entry of dust.
Do not drop any bolts or tools into the inverter with converter assembly.
Clean the tools before use.
PRECAUTION WHEN HANDLING ELECTRONIC COMPONENTS
Do not touch the terminals of the connectors or areas other than the specified on circuit boards, as static electricity may be applied to parts and damage them.
Do not drop electronic components such as circuit boards or subject them to impact.
Keep the removed parts free from dust.
Electronic components are very sensitive. Be sure to observe the handling instructions.
PRECAUTION WHEN HANDLING PARTS
Do not drop parts or subject them to impact.
If a part is subject to impact, replace it with a new one.
Be sure to observe the handling instructions to prevent parts from being damaged.
Do not lower the vibration dampening connectors until the motor generator control ECU sub-assembly is installed to the inverter with converter assembly.
PRECAUTION WHEN SUSPENDING WORK
If suspending work, cover parts with clean pieces of paper to prevent entry of dust and foreign matter.
Arrange the removed parts in the correct order so that they can be installed to the correct position and with the correct orientation.
It is recommended to take pictures of parts before removing them to ensure correct installation.